user_guide:howto:jupyter

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
user_guide:howto:jupyter [2021/06/03 18:14]
lkastner
user_guide:howto:jupyter [2021/06/15 09:02] (current)
lkastner [jupyter] Try other browser
Line 9: Line 9:
 ninja -C build/Opt install ninja -C build/Opt install
 </​code>​ </​code>​
-in your polymake source. Then please use the polymake binary from the folder you installed polymake in.+if working with the polymake source. Then please use the polymake binary from the folder you installed polymake in
 + 
 +If you use a version of polymake installed via your package manager, make sure you have the ''​polymake-config''​ binary. Try running 
 +<​code>​ 
 +polymake-config --version 
 +</​code>​ 
 +in a terminal. For example for Ubuntu it is not enough to have the ''​polymake''​ package installed, you will also need ''​libpolymake-dev''​.
  
 ===== Setup ===== ===== Setup =====
Line 56: Line 62:
  
 ===== Troubleshooting ===== ===== Troubleshooting =====
 +If the polymake kernel does not start for you, look at the output of jupyter in the terminal and search for any error messages.
 +
 +If you experience issues it makes sense to try a different browser.
 +
 +==== JuPyMake.PolymakeError:​ polymake::​Main - /​usr/​lib/​polymake/​shared is not a symlink ====
 +This error sometimes appears with polymake installed by the package manager. It can be fixed by manually setting the symlink
 +<​code>​
 +cd /​usr/​lib/​polymake
 +sudo ln -s ../​../​share/​polymake shared
 +</​code>​
 +
  
 ==== polymake configuration ==== ==== polymake configuration ====
-The default configuration used by the jupyter kernel is the one in `$HOME/​.polymake`. If you need to reconfigure a rules file, it is easiest to reconfigure it outside of jupyter. Note that the configuration is only saved to `$HOME/​.polymakeonce polymake gets closed using `exit;`.+The default configuration used by the jupyter kernel is the one in ''​$HOME/​.polymake''​. If you need to reconfigure a rules file, it is easiest to reconfigure it outside of jupyter. Note that the configuration is only saved to ''​$HOME/​.polymake'' ​once polymake gets closed using ''​exit;''​.
  
 Advance users can use a different configuration folder in the following way: Advance users can use a different configuration folder in the following way:
  • user_guide/howto/jupyter.1622744095.txt.gz
  • Last modified: 2021/06/03 18:14
  • by lkastner